Filter
Top Products
Configuring Data-Link Switching Plus
DLSw+ Configuration Examples
BC-312
Cisco IOS Bridging and IBM Networking Configuration Guide
78-11737-02
See the DLSw+ Design and Implementation Guide “Using Show and Debug Commands” chapter and the
Cisco IOS Bridging and IBM Networking Command Reference (Volume 1 of 2) for details of the
commands.
DLSw+ Configuration Examples
The following sections provide DLSw+ configuration examples:
• DLSw+ Using TCP Encapsulation and LLC2 Local Acknowledgment—Basic Configuration
Example, page 312
• DLSw+ Using TCP Encapsulation with Local Acknowledgment—Peer Group Configuration
Example 1, page 314
• DLSw+ Using TCP Encapsulation with Local Acknowledgment—Peer Group Configuration
Example 2, page 316
• DLSw+ with SDLC Multidrop Support Configuration Examples, page 318
• DLSw+ with LLC2-to-SDLC Conversion Between PU 4-to-PU 4 Communication Example,
page 319
• DLSw+ Translation Between Ethernet and Token Ring Configuration Example, page 320
• DLSw+ Translation Between FDDI and Token Ring Configuration Example, page 321
• DLSw+ Translation Between SDLC and Token Ring Media Example, page 322
• DLSw+ over Frame Relay Configuration Example, page 324
• DLSw+ over QLLC Configuration Examples, page 325
• DLSw+ with RIF Passthrough Configuration Example, page 326
• DLSw+ with Enhanced Load Balancing Configuration Example, page 327
• DLSw+ Peer Cluster Feature Configuration Example, page 328
• DLSW+ RSVP Bandwidth Reservation Feature Configuration Example, page 329
• DLSw+ RSVP Bandwidth Reservation Feature with Border Peers Configuration Example, page 330
• DLSw+ with Ethernet Redundancy Configuration Example, page 331
• DLSw+ with Ethernet Redundancy Enabled for Switch Support Configuration Example, page 332
DLSw+ Using TCP Encapsulation and LLC2 Local Acknowledgment—Basic
Configuration Example
This sample configuration requires the following tasks, which are described in earlier sections of this
document:
• Define a Source-Bridge Ring Group for DLSw+
• Define a DLSw+ Local Peer for the Router
• Define DLSw+ Remote Peers
• Assign DLSw+ to a local data-link control