Filter
Top Products
4-11
Cisco 6500/7600 Manager User Guide
OL-2209-01
Chapter 4 Deploying the C65/76M
Deployment and Commissioning Process
Figure 4-5 Network Element Dialog Box
When the dialog box is displayed, select the Configuration tab. In the CLI
Passwords section, specify the Telnet Password and Enable Password parameters.
The Telnet Password is the password used to connect to the switch using the
Telnet protocol. The Enable Password is the password used to enter the enable
mode on the switch or router. All values entered in these text fields will be
displayed as “*”.
To specify the SNMP read and write community strings, select the SNMP tab and
enter the correct SNMP read/write community strings.
Note The IP Discovery process only fills in the SNMP community strings based on
the version of SNMP discovered on the switch or router. In Figure 4-6, the
read and read-write community strings are specified as public and private,
respectively, because “private” was specified in the IP Discovery window
(see Figure 4-3). The community string used in the IP Discovery window
should be the read-write SNMP community.