Filter
Top Products
2-2
Cisco IE 3010 Switch Hardware Installation Guide
78-19581-02
Chapter 2 Switch Installation
Warnings
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available.
Statement 1024
Warning
This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit.
Statement 1028
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning
For connections outside the building where the equipment is installed, the following ports must be
connected through an approved network termination unit with integral circuit protection.
10/100/1000 Ethernet
Statement 1044
Warning
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of:
140°F (60°C)
Statement 1047
Warning
Installation of the equipment must comply with local and national electrical codes.
Statement 1074
Note For U.S. installations, refer to national electrical code ANSI/NFPA 70.
Warning
To prevent airflow restriction, allow clearance around the ventilation openings to be at least:
1.75 in. (4.4 cm).
Statement 1076
Warning
Avoid using or servicing any equipment that has outdoor connections during an electrical storm.
There may be a risk of electric shock from lightning.
Statement 1088