Filter
Top Products
Setting up the Hardware
Starting the NSS
NSS3000 Series Network Storage System Getting Started Guide 9
2
Starting the NSS
Follow these steps to start the NSS.
STEP 1 Press the Power button on the front of the chassis.
STEP 2 Verify that the Power LED on the front of the NSS chassis turns yellow. If the LED is
not yellow, see the ”Power Button LED” section on page 25.
STEP 3 Confirm that the LCD display on the front of the chassis displays the IP address
assigned to the chassis. See ”Using the NSS3000 LCD Panel” on page 10.
STEP 4 If the IP address assigned to the chassis starts with 169.254, it means that the
address is self-assigned. This happens if there is no DHCP server on the network
!
CAUTION If you disconnect and reconnect the chassis (while it is turned on) from or to the
network, you must wait 15 seconds before you can access the chassis through
the network.
STEP 5 The hardware installation is complete.
Continue to “Configuring the NSS,” on page12.
188912