Filter
Top Products
Setting up the Hardware
Installing the Disk Drives
NSS3000 Series Network Storage System Getting Started Guide 4
2
STEP 4 Open the front door of the chassis.
STEP 5 From disk bay 1, remove the disk tray.
To remove the tray, push in the tab on the latch on the front of the tray, and then
open the latch. Pull out the tray.
STEP 6 Position the disk drive into a disk tray. Then, attach the disk drive to the tray by
inserting the disk drive screws into the four holes at the bottom of the tray and
tightening them with a Phillips screwdriver.
Alternatively, you can attach the disk drive to the tray by inserting two screws into
the holes on each side of the tray and tightening them.
STEP 7 Insert the tray back into the empty bay of the chassis.
STEP 8 Apply even pressure to both corners of the tray while you insert the tray fully into
position in the chassis. Then, close the latch of the tray.
188909
273160