Filter
Top Products
15
Chapter 3: Configuring the Network Storage System
(NSS)
Getting Started Guide
Chapter
3
To set up your computer to communicate with the NSS:
1. Set your computer’s network settings to the following:
• IP Address: 169.254.x.y (where x and y can be any number between 1 and 254). For
example, 169.254.1.2.
• Subnet Mast (Netmask): 255.255.0.0.
After you configure your computer, you can log into the NSS configuration interface. You can
configure the NSS network IP settings as required.
Step 2: Log into the Configuration Interface
This step depends on whether your NSS is set up within the Linksys One environment or if it is in a
standalone environment. The only differences to note in terms of the configuration steps is that the
log in steps are different and that if you are logging into the Linksys One environment, the
configuration pages appear within the Linksys One window (window-in-window). There is no
difference in the actual details within the configuration pages.
Option A: Linksys One Environment Login Steps
To log into the configuration interface when the NSS is installed in a Linksys One Environment:
1. Login to the SVR.
2. Click the L1 Devices tab.
The NSS appears in the list of devices. Note that you can change your administrator password
and the NSS hostname from this window.
3. Click Show Details.