Cisco Systems NSS4000 Network Card User Manual


 
23
Chapter 3: Configuring the Network Storage System
(NSS)
Getting Started Guide
Chapter
3
Step 6: Virtualize Storage within your Network
The NSS virtualization feature lets you create storage physically located on other network NSS units
into one logical storage unit. The recommended network configuration for using virtualization is to
use an NSS6000 series to operate as the “master” storage device (the “slave” devices can either be
NSS6000 series, NSS4000 series, or NSS2000 series devices). This configuration setup means that
you can export storage (must be an unused disk drive or configured array) from a slave NSS and
then import the storage into the master NSS. The supported RAID level for virtualized storage is
JBOD (although the JBOD can consist of concatenated exported arrays).
Exporting Storage to your Network
To export storage to the network:
1. Log into the configuration interface for the device from which you are exporting storage.
2. From the Manager Menu, click Storage Virtualization.
NOTE: After you configure a virtual RAID, you cannot
migrate the disks used for that RAID to another NSS. You
also cannot export storage from a device that uses
imported storage.