Filter
Top Products
D-6
Cisco Wireless ISR and HWIC Access Point Configuration Guide
OL-6415-04
Appendix D Error and Event Messages
802.11 Subsystem Messages
Error Message DOT11-4-NO_MBSSID_VLAN: No VLANs configured in MBSSID mode.
[characters] not started
Explanation No VLAN configured in MBSSID mode. The indicated interface was not started.
Recommended Action Add at least one SSID with the VLAN on the indicated interface configuration.
Error Message DOT11-4-NO_MBSSID_SHR_AUTH: More than 1 SSID with shared
authentication method in non-MBSSID mode. %
Explanation Not more than one SSID can have shared authentication method when MBSSID is not
enabled.
Recommended Action Remove SSID from Dot22Radio radio interface or change authentication mode
for SSIC to open configuration.
Error Message DOT11-4-FW_LOAD_DELAYED: Interface [interface], network filesys not
ready. Delaying firmware [characters] load
Explanation The network filesystem was not running or not ready when trying to flash new firmware
into the indicated interface. Loading the identified firmware file has been delayed.
Recommended Action Make sure the network is up and ready before attempting to reflash the new
firmware.
Error Message DOT11-2-FLASH_UNKNOWN_RADIO: Interface [interface] has an unknown
radio
Explanation The radio type could not be determined when the user attempted to flash new firmware
into the indicated interface.
Recommended Action Reboot the system and see if the firmware upgrade completes.
Error Message DOT11-4-UPLINK_ESTABLISHED: Interface [interface] associated to AP
[characters] [characters] [characters]
Explanation The indicated repeater has associated to the indicated root access point. Clients can now
associate to the indicated repeater and traffic can pass.
Recommended Action None.
Error Message DOT11-2-UPLINK_FAILED: Uplink to parent failed: [characters]
Explanation The connection to the parent access point failed for the displayed reason. The uplink
will stop its connection attempts.
Recommended Action Try resetting the uplink interface. Contact Technical Support if the problem
persists.