Filter
Top Products
2-4
Cisco Wireless ISR and HWIC Access Point Configuration Guide
OL-6415-04
Chapter 2 Configuring Radio Settings
Configuring Network or Fallback Role
Bridge Features Not Supported
The following features are not supported when a Cisco ISR series access point is configured as a bridge:
• Clear Channel Assessment (CCA)
• Interoperability with 1400 series bridge
• Concatenation
• Install mode
• EtherChannel and PageP configuration on switch
For root and non-root bridging mode operations, only bridge-group mode using BVI interface is
supported. Routing mode is not supported for root and non-root bridging operations.
Sample Bridging Configuration
The following is a sample of a Root Bridge Configuration:
!
aaa new-model
!
!
aaa group server radius rad_eap
server 20.0.0.1 auth-port 1812 acct-port 1813
!
aaa authentication login eap_methods group rad_eap
!
aaa session-id common
!
resource policy
!
mmi polling-interval 60
no mmi auto-configure
no mmi pvc
mmi snmp-timeout 180
!
dot11 ssid airlink2-bridge
vlan 1
authentication open
authentication key-management wpa
wpa-psk ascii 0 12345678
!
dot11 priority-map avvid
ip cef
!
!
no ip domain lookup
!
!
bridge irb
!
!
interface FastEthernet0/0
no ip address
shutdown
duplex auto
speed auto
!
interface FastEthernet0/1