Filter
Top Products
CHAPTER
Preparing for Installation 2-1
2
Preparing for Installation
This chapter describes the general equipment, safety, and site preparation requirements for installing
the PA-T3 port adapters.
• Parts and Tools Required, page 2-1
• Software and Hardware Requirements, page 2-2
• PA-T3 Port Adapter LEDs, page 2-3
• PA-T3 Receptacles and Cables, page 2-5
• Interoperability Guidelines for PA-T3 Serial Port Adapter DSUs, page 2-5
• Safety Guidelines, page 2-6
• FCC Class A Compliance, page 2-8
Parts and Tools Required
You need the following tools and parts to install a port adapter. If you need additional equipment,
contact a service representative for ordering information.
• PA-T3 serial port adapter and one of the following:
— VIP2-15(=), VIP2-20=, VIP2-40(=), or VIP2-50(=) motherboard
— Catalyst RSM/VIP2-15(=) or Catalyst RSM/VIP2-40(=) motherboard
— Cisco 7100 series router with at least one available port adapter slot
— Cisco 7200 series router with at least one available port adapter slot
— Cisco uBR7200 series router with at least one available port adapter slot
• 75-ohm coaxial serial interface cables
• Number 1 Phillips screwdriver and a 3/16-inch flat-blade screwdriver
• Your own ESD-prevention equipment or the disposable grounding wrist strap included with all
upgrade kits, field-replaceable units (FRUs), and spares