Filter
Top Products
VIP2 and the PA-T3 Port Adapter 3-5
Installing a Port Adapter
Figure 3-4 Pulling a Port Adapter Out of a Slot—Partial Port Adapter View
Step 7
If you removed a port adapter, place it in an antistatic container for safe storage or
shipment back to the factory. If you removed a blank port adapter, no special handling is
required; however, store the blank port adapter for potential future use.
This completes the procedure for removing a new port adapter on a VIP2.
Installing a Port Adapter
Following is the standard procedure for installing a port adapter on the VIP2.
Step 1 Remove the new port adapter from its antistatic container and position it at the opening
of the slot.
Step 2 Carefully align the port adapter carrier between the upper and the lower edges of the port
adapter slot, as shown in Figure 3-5.
Figure 3-5 Aligning a Port Adapter in a Port Adapter Slot
H3149
H3150
Upper edge
Lower edge
Carrier