Filter
Top Products
3-2
Cisco SFS 3012R Multifabric Server Switch Hardware Installation Guide
OL-11187-01
Chapter 3 Installing and Removing Server Switch Field Replaceable Units (FRUs)
Installing a Controller Module
Installing a Controller Module
To install a controller module, perform the following steps:
Step 1 Ground yourself with an approved ground wrist strap.
Step 2 Remove the blanking panel if one resides in the slot.
Step 3 Remove the controller module from any packaging.
Step 4 Extend the ejector lever on the module completely.
Step 5 Insert the controller module into slot 1 (left-most) or slot 14 (right-most) so that the ejector lever sits on
the bottom-left-hand side of the module, as shown in Figure 3-1.
Step 6 Push the controller module firmly into the slot. The ejector lever begins to close.
Figure 3-1 Inserting the Controller Module
180742