Filter
Top Products
4-2
Cisco SFS 3012R Multifabric Server Switch Hardware Installation Guide
OL-11187-01
Chapter 4 Viewing and Updating the Software Image
Viewing the Software Image Version
Viewing the Software Image Version with the CLI
Use the CLI to view software versions on the chassis as follows:
Step 1 To view the primary software image version for all cards in the chassis, use the show card-inventory
command, as shown in the following example:
SFS-3012R# show card-inventory
================================================================================
Card Resource/Inventory Information
================================================================================
slot-id : 1
used-memory : 77040 (kbytes)
free-memory : 50272 (kbytes)
used-disk-space : 45048 (kbytes)
free-disk-space : 57331 (kbytes)
last-image-source : TopspinOS-2.0.0/build495
primary-image-source : TopspinOS-2.0.0/build495
image : TopspinOS-2.0.0/build495
cpu-descr : PPC 440GP Rev. C - Rev 4.129 (pvr 4012 0481)
fpga-firmware-rev : 6
ib-firmware-rev : 200000000
slot-id : 10
used-memory : 47676 (kbytes)
free-memory : 34948 (kbytes)
used-disk-space : 8909 (kbytes)
free-disk-space : 33361 (kbytes)
last-image-source : TopspinOS-2.0.0/build495
primary-image-source : TopspinOS-2.0.0/build495
image : TopspinOS-2.0.0/build495
<output truncated>
Interpret the display as follows:
a. Look for the primary-image-source field for each slot. The slots are identified in Figure 1-3 on
page 1-4.
b. Determine whether or not any slot has a software image version (primary-image-source) that is
older then the others. This slot will need its image updated.
c. Compare your most recent image with the most recent image available. Check the Cisco.com site or
your ftp site for details about image availability. Consider updating to the newer image, if available.
d. If you need to download a new image, note the amount of memory and disk space available. Check
also the file size of the new image that you will download from the Cisco.com website or from the
ftp site and determine whether or not you need to create space.
e. Examine the files listed in the image field of the display. Any file listed in the image field that is
neither the last-image-source nor the primary-image-source is a candidate for deletion.
Step 2 Use the dir image command to view all existing boot images on the chassis, and determine whether or
not they are currently installed, as shown in the following example:
SFS-3012R> enable
SFS-3012R# dir image
=============================================================================
Existing Boot-Images on System
=============================================================================
slot date-created size file-name
--------------------------------------------------------------------------------
1 Tue Nov 25 18:46:32 2003 30695264 Topspin360-TopspinOS-2.0.0-build212.img