Filter
Top Products
Address Table Commands
bridge multicast address
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 77
5
Default Configuration
Filtering Multicast addresses is disabled. All Multicast addresses are flooded to all
ports.
Command Mode
Global Configuration mode
User Guidelines
If Multicast devices exist on the VLAN, do not change the unregistered Multicast
addresses state to drop on the switch ports.
If Multicast devices exist on the VLAN and IGMP-snooping is not enabled, the
bridge multicast forward-all command should be used to enable forwarding all
Multicast packets to the Multicast switches.
Example
In the following example, bridge Multicast filtering is enabled.
Console(config)# bridge multicast filtering
bridge multicast address
The bridge multicast address Interface Configuration (VLAN) mode command
registers a MAC-layer Multicast address in the bridge table and statically adds
ports to the group. To unregister the MAC address, use the no form of this
command.
Syntax
bridge multicast address {
mac-multicast-address
|
ip-multicast-address
}
bridge multicast address {
mac-multicast-address
|
ip-multicast-address
} [add |
remove] {ethernet
interface-list
| port-channel
port-channel-number-list
}
no bridge multicast address {
mac-multicast-address
|
ip-multicast-address
}