Filter
Top Products
Address Table Commands
bridge multicast address
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 78
5
Parameters
•
add —
Adds ports to the group. If no option is specified, this is the default
option.
• remove — Removes ports from the group.
•
mac-multicast-address —
A valid MAC Multicast address.
•
ip- multicast-address —
A valid IP Multicast address.
•
interface-list
— Separate nonconsecutive Ethernet ports with a comma and
no spaces; a hyphen is used to designate a range of ports.
•
port-channel-number-list
— Separate nonconsecutive port-channels with a
comma and no spaces; a hyphen is used to designate a range of port-
channels.
Default Configuration
No Multicast addresses are defined.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
If the command is executed without add or remove, the command only registers
the group in the bridge database. Static Multicast addresses can only be defined
on static VLANs.
Example
The following example registers the MAC address:
Console(config)# interface vlan 8
Console(config-if)# bridge multicast address 01:00:5e:02:02:03