Filter
Top Products
CBM-270 User’s Manual
CITIZEN
67
ESC v (Serial Interface Only)
[Function] Transmitting the printer status
[Code] <1B> H <76> H
[Outline] Current printer status is transmitted..
[Caution]
·
Status sent out consists of 1 byte whose content is as in the table below.
·
In DTR/DSR control, after receptible state of the host (DSR signal being in
SPACE state) is confirmed, only 1 byte is transmitted. In XON/XOFF control,
DSR signal state not being confirmed, only 1 byte is transmitted.
·
In DTR/DSR control, when the host is in unreceptible state(DSR signal being
in MARK state), it waits until receptible state is created.
·
In paper end (paper near end) status, this command may be unreceptible state
due to BUSY state.
Remarks. This command is valid only for serial interface model.
Value
Bit Function
01
0 Not defined
1 Not defined
2 Paper end With paper Without paper
3 Not defined
4 Not used Fixed to 0
-
5 Not defined
6 Not defined
7 Not defined
[Sample Program]
OPEN "COM1:N81NN" AS #1 ;
PRINT #1, CHR$ (&H1B) ; "v" ;
A$ = INPUT$ (1, #1) ;
CLOSE #1
END