Filter
Top Products
— 11 —
2.2 Printer Cover Inside
● Interface connector (Serial, parallel, etc.)
Connects to the interface cable. A DIP switch is provided on the serial interface board.
● Cash drawer kick-out connector
Connects to the cable from the cash drawer.
● AC inlet (AC power type)
Connects to the AC power cord.
● Power connector (DC power supply type)
Connects to the cable from DC power source.
Interface connector
(Serial, parallel, etc.)
Cash drawer
kick-out connector
Power connector
(DC power supply type)
Rear Connectors
Interface board
mounting screws
AC inlet
(AC power type)
USB connector
● Paper feed roller
Feeds paper as part of print
mechanism.
● Paper-near-end sensor
Detects near paper end, change
position in accordance with the outer
diameter of paper core.
● Auto cutter
Cuts the paper with a command at the
end of printing. Cutting method is
selectable between partial cut and full
cut with a command.
* Factory default of the memory SW4-8
is set to "Partial cut", so that a
command will be ignored.
However, full cutting is set for the
model supporting label.
● Manual cutter
Tears the paper by hand.
● Print (thermal) head
Prints characters and/or graphic data
on thermal paper.
● Paper-end sensor
Stops printing when this sensor
detects paper end.
Print (thermal)
head
Manual cutter
Auto cutter
Paper-near-end
sensor
Paper feed roller
Paper-end sensor