Filter
Top Products
14
Maintenance
Changing the Paper Roll
To operate your data printer, the paper rolls must have the
following specifications:
– Standard paper roll
– Wood-free paper, 60 g
– Width: 57.5 ± 0.5 mm
– Diameter: 65 mm max.
– Core diameter: 8 mm min.
§ To open the paper roll compartment, lift the cover
Remove the old roll core
$ Place a new paper roll on a flat surface
$ The beginning of the paper must be on the bottom and
facing you
§ Using your other hand, thread the paper through the slot
underneath the ink ribbon
§ To transport the paper through the ink ribbon cassette,
press the key several times.
> The paper will be threaded into, then out of the ink ribbon
cassette
15
Release the roll holders on both sides
To close the paper roll compartment, lower the cover
Changing the Ink Ribbon Cassette
To operate your data printer, you must use a black ink
ribbon cassette,
§ Lift the cover of the paper roll compartment
§ To remove the paper from the ink ribbon cassette,
turn the paper roll opposite to the paper feed direction
§ Press down on the right side of the cassette
> The left side of the cassette will lift up
§ Remove the cassette
§ Insert a new ink ribbon cassette from the top
> The cassette will lock into place
$ If necessary, turn the small tension wheel located
on the left in the direction of the arrow until the ribbon
is stretched taut in front of the paper
§ To thread the paper, refer to “Changing the Paper Roll”
§ Lower the cover of the paper roll compartment to close it