Filter
Top Products
2-4
2.4 Printer Setup Mode
To enter the Printer Setup Mode, press and hold down the Pause key then press
the Feed key and release both keys. In a few seconds you will hear a beep and
see Transfer or DirectTM displayed on the LCD screen. The functions of the
control keys are described below.
Changes to the printer configuration are stored in nonvolatile memory. This
guarantees that the printer configuration is maintained even after the power is
turned off.
[Functions]
Print mode selection, peeling sensor ON/OFF, auto-cutter ON/OFF, etc.
n Pause key: Selects the mode.
n Feed key: Selects the mode item.
n Stop key: Saves settings and returns the printer to normal operating mode.
Mode item Indication
¯
¯¯
¯
Direct-thermal/thermal Transfer ® Direct TM ®
transfer printing
¯
¯¯
¯
Peeling sensor Peel OFF ® Peel ON ®
¯
¯¯
¯
Auto-cutter Cut OFF® Cut ON ®
¯
¯¯
¯
Tearing Tear OFF ® Tear ON ®
¯
¯¯
¯
Sensor selection Edge ® Reflect ® ContinuP ®
2.5 Self-Test Mode
The printer can be placed into self-test mode by pressing and holding the Feed key
while turning the printer on.
Note: Proper use of this mode requires a minimum label size of 4” x 4”. Use of
a smaller label will prevent the user from seeing all printed information,
and verifying the print quality across the entire print head.