Filter
Top Products
2-6
2.6 System Maintenance Mode
To enter the printer’s maintenance mode, press and hold the Pause, Feed and
Stop keys simultaneously while turning on the printer’s power. In a few
seconds you will hear a beep and see S Mainte displayed on the LCD screen.
Note: To reset all values to default settings, continue to hold these keys for
an additional four (4) seconds, until you hear a second beep and see
S/I Init displayed on the screen. See the chart at the end of this
section for the printers default values.
After entering this mode the printer will display the first of several parameters
for you to set. Select each parameter (Mode) by pressing the Pause key, and
make changes to that selection by pressing the Feed key to cycle through the
available choices.
Pressing the Stop key will save your settings and return the printer to normal
operating mode. After you press the Stop key, the printer will display RESET
in the LCD screen and, a few seconds later, On Line.
Note: Do not turn off the printer until you see ‘On Line’ in the display, or
your changes may be lost.
Mode item Indication
¯
¯¯
¯
Baud rate 9600bps ® 19200bps ® ¼¼¼ ® 4800bps ®
¯
¯¯
¯
Data length 8 bits ® 7 bits ®
¯
¯¯
¯
Native NativeON® NativeOF ®
¯
¯¯
¯
Adjustable sensor AJSensOF ® AJSensON ®
¯
¯¯
¯
Voltage setting PE#.##V ® BL#.##V®