Filter
Top Products
4-3
ProLiant 3000 Setup and Installation Guide
Writer: Tom Erber Project: ProLiant 3000 Setup and Installation Guide Comments: 296908-002
File Name: E-CH04.DOC Last Saved On: 1/27/98 4:20 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
1. Back up your server data.
2. Shut down the operating system in an orderly manner as directed in your
operating system instructions.
3. Power down the server and remove the power cord.
IMPORTANT: The system power in the ProLiant 3000 server does not
completely shut off with the front panel Power On/Standby switch. The two
positions of the switch functions as ON and STANDBY, rather than ON and
OFF. The STANDBY position removes power from most of the electronics
and the drives but portions of the power supply and some internal circuitry
remain active. Consequently, to completely remove all power from the
system, you must disconnect the power cord from the server. In systems
with multiple power supplies, you must disconnect all the power cords to
completely remove power from the system.
NOTE: After you move the Power On/Standby switch to the Standby position it
may take the operating system up to 30 seconds before shutting down the power.
WARNING: Before removing the server top panel, ensure that
the server is turned off and that the power cord is disconnected
from the electrical outlet.
4. Disconnect any other external equipment connected to the computer.
5. Loosen the two thumbscrews on the front of the unit.