Filter
Top Products
2–8 Compaq iPAQ Microportable Projector MP1200 User’s Guide
Using the Projector
Adjusting the Projected Image
There are three ways to adjust the projected image:
■
Adjusting the projector height
■
Adjusting the image size
■
Adjusting the projector focus
Adjusting the Projector Height
The projector has a built-in elevator foot that can raise the
projector approximately 1 inch (2.54 cm).
To adjust the height:
1. Raise the projector to the desired display angle, then press the
elevator button
1
to release the elevator foot
2
.
2. To lower the display angle, press the elevator button again
and press down on the projector to lower it.
Ä
CAUTION: Failure to press the elevator button before adjusting the
elevator foot can result in damage to the elevator mechanism.
3. Turn the screw on the rear foot
3
to raise and lower the back
side of the projector for balance.
261799-001.book!!Page!8!!Thursday,!April!25,!2002!!3:13!PM