Filter
Top Products
3–12 Compaq iPAQ Microportable Projector MP1200 User’s Guide
Using the On-Screen Display Menu
■
Multiple inputs are active. Use the OSD to select the
alternate sources—The projector has detected multiple
inputs. This message may appear when powering up,
returning from Standby, or when the
Source
button is pressed
on the projector or remote control. If no selection is made
within 10 seconds, the currently displayed source will remain
as the active source. Press the
Source
button on top of the
projector or on the remote control to review and select from
the active video sources.
■
Lamp May Fail Soon. Replacement Suggested—Indicates
the lamp is approaching failure. The message will remain on
the screen for 10 seconds or until the on-screen menu
Enter/Accept
button is pressed. This message appears once
when powering up or returning from Standby until the lamp
is replaced. After the lamp is changed, access the Service
menu to reset the lamp hours counter. Refer to the “Replacing
the Projector Lamp Module” section of Chapter 7 for
information on resetting the lamp hours counter.
✎
The 10-second timeout is the default value. To change the timeout
value, select the Management menu, select the OSD Timeout
menu, and change the timeout from 1 to 40 seconds.
✎
When the projector is started, the Compaq banner displays for
approximately 10 seconds. To skip this banner display, turn off
the function using the OSD menu.
261799-001.book!!Page!12!!Thursday,!April!25,!2002!!3:13!PM