Filter
Top Products
IntelliStripe 380
8
Opto-Sensor Inputs
The Main PCB provides inputs for the three opto-sensors (Front, Encode, and Rear).
Rotary Pulse Generator
The Main PCB provides input for the MagTek 75/210 bpi Rotary Pulse Generator (RPG).
External SAM Ranch Interface, Optional
The Main PCB provides resources for interconnect, securement, and power of an optional SAM
Ranch PCB. The optional SAM Ranch PCB is accessed from the hatch door at the bottom of the
Encoder/Reader.
Dual Color LED
The Main PCB provides facilities for a dual color, red/green PCB. The LED is located on the
front bezel of the Encoder/Reader. When the unit is powered up, the LED will blink green or red
until the Host commands it to a different state. Green means the unit is ready for normal
operation. Red means a card is jammed in the unit and should be manually removed.
ISO-8 Smartcard Connector with Landing Switch
The Main PCB provides resources to support an interface with an ISO-8 smartcard connector
with its associated landing switch. The electronics meet EMV Level 1 requirements.
3-Track Read/Encode Magnetic Head
The Main PCB supports an interface to a 3-Track Read/Encode Magnetic Head. A flex-cable
circuit connects the magnetic head to the Main PCB.
DC Motor
The Main PCB supports a bidirectional drive interface to a DC motor. The motor drives the card
in the forward and reverse directions in the transport. The motor can also be driven with a small
“holding” current to keep a card positioned over the Smart Card contact block during a Smart
Card session.
Microcontroller LED Indicator
The Main PCB supports a “watchdog” LED, which blinks on and off providing visual indication
that the microcontroller is in a normal state of operation. The LED can be viewed when the
bottom access hatch is removed from the enclosure.