Filter
Top Products
21
APPENDIX A. DIMENSIONS FOR MOUNTING
MOUNTING
The bottom of the unit is shown in Figure 2-1 and 2-2. The IntelliStripe 380 may be mounted in
one of three ways: 1) foot pads, 2) set of mounting holes for 3 screws (4 x 40), and 3) 4 lock-in-
place slots.
The mounting dimensions of the 3 screw holes and the 4 lock-in-place slots are shown in Figure
A-1.
Footpad Mounting
The footpads are mounted at the factory if it is the default. Simply place the unit on a level
surface with approximately 4 inches clearance from obstructions at the front of the unit for card
clearance. Leave enough room at the rear of the unit for cable clearance.
Mounting Hole Screws
Locate the 3 screw holes (4 x 40 screws) shown in Figure 2-1. The length of the screws depends
on the thickness of the mounting surface. Drill 3 holes in the mounting surface that match the set
of screw holes. The screws are mounted from under the mounting surface and into the bottom of
the IntelliStripe 380.
Lock-in-place-slots
The overall dimensions of the unit are shown in Figure A-2.
The MagTek Mounting Plate, Figures A-3 and A-4, show the use of the Lock-in-place slots
(Refer also to Figures 2-2). In the example the holes are placed over mounted inserts and the
unit is pulled the length of the slots forcing the thickest part of the plate to lock the unit in place.
The value and tolerances of the plate at the end of the slots are .087” ±.005” (Figure A1), and the
value and tolerances of the “stem” of the mushroom-shaped inserts are .085” ±.005” as shown in
Figure A-4.
Flange
The flange shown in Figure 2-2 may be used to screw the unit to the mounting surface using a #4
screw. It can be used with any mounting configuration.