Filter
Top Products
Appendix B. Power Cord Set Requirements
B.1 3-Conductor Power Cord Set
The wide range input feature of your computer permits it to operate from
any line voltage from 90 to 264 volts AC.
The power cord set received with the computer meets the requirements for
use in the country where you purchased the equipment.
Power cord sets for use in other countries must meet the requirements of
the country where you use the computer. For more information on power cord
set requirements, contact your Compaq authorized reseller or service
provider.
General Requirements
The requirements listed below are applicable to all countries:
1. The length of the power cord set must be at least 6.00 feet (1.8 m)
and a maximum of 9.75 feet (3.0 m).
2. All power cord sets must be approved by an acceptable accredited agency
responsible for evaluation in the country where the power cord set will
be used.
3. The power cord set must have a minimum current capacity of 10A and a
nominal voltage rating of 125 or 250 volts AC, as required by each
country's power system.
4. The appliance coupler must meet the mechanical configuration of an EN
60 320/IEC 320 Standard Sheet C13 connector, for mating with appliance
inlet on the Switch Box.
Country-Specific Requirements
3-Conductor Power Cord Set Requirements - By Country
===========================================================================
Country Accredited Agency Applicable Note Numbers
===========================================================================
Australia EANSW 1
Austria OVE 1
Belgium CEBC 1
Canada CSA 2
Denmark DEMKO 1
Finland SETI 1
France UTE 1