Filter
Top Products
6.4.2 MPEG Connector Door
The MPEG connector door [2] provides visual access to the MPEG connector
for guiding the connector into place when installing the bottom cover
assembly with the connector attached to the bottom cover (Figure 6-8).
Procedures presented later in this manual prescribe separating the MPEG
connector from the bottom cover at disassembly and not removing the MPEG
connector door.
If you choose to leave the MPEG connector attached to the bottom cover,
you should remove the MPEG connector door for visual access to the MPEG
connector and its connecting location on the main board. Use a small
flat-blade screwdriver to pry the MPEG connector door loose.
Chapter 6.5 Bottom Cover Assembly
The bottom cover assembly is spared as a unit and consists of:
o Bottom cover
o MPEG connector access door
o Feet
o Labels
The feet are also spared separately. Feet installation is described in
Section 6.4.2. The feet, labels, and MPEG connector access door are
preinstalled.
To remove the bottom cover assembly, complete the following steps:
1. Prepare the expansion base for disassembly as described in Section 6.3.
2. Place the expansion base face down on the work surface and remove the
ten screws that secure the bottom cover to the expansion base
(Figure 6-9).