Filter
Top Products
Installing PC-CAM 600 5
Buttons and
LCD on
PC-CAM 600
The following section explains the functions of the buttons and LCD on your PC-
CAM 600. Refer to Figure 1-1 and Figure 1-2 for the location of these buttons and
LCDs on your camera.
Buttons The following buttons are found on your PC-CAM 600:
❑ Power button
To turn on your camera, press this button. You can only turn on your camera
when it is disconnected from the computer.
To turn off your camera, press and hold this button for two seconds.
Note: The camera will turn itself off if it is left idle for three minutes.
❑ Operation Mode button
This button will change the camera’s operation mode each time it is pressed.
There are eight modes of operation: Single snapshot (normal resolution),
Single snapshot (high resolution), Single snapshot (low resolution), Self-timer
single snapshot (normal resolution), Self-timer single snapshot (high
resolution), Multiple snap shot, Video Recording and Audio Recording. To erase
all the data from your camera, press this button together with the Snapshot
button and hold for 3 seconds.
❑ Flash Mode button
This button will change the camera’s flash mode each time it is pressed. There
are four flash modes: Auto, Always, Red Eye and Disabled. To erase the last
picture taken, press this buton together with the Snapshot button and hold for
3 seconds
❑ Snapshot button
This button is used for taking photos and videos. It is a two-stage button.
Pressing the button halfway (the first stage) will allow the camera to make the
necessary adjustments for flash and exposure. Pressing the button completely
(the second stage) allows the camera to take a picture or video.