Filter
Top Products
CRESTRON GREEN LIGHT
®
EXPRESS Power Switching Cabinet GLPX-HSW-FT
Testing
Ma
Ligh
To t
and t
rele
NO ram may change the settings if the Override mode is not enabled.
nual Control
ting modules can be manually controlled from the front panel.
oggle the output between off and on, tap the appropriate ON/OFF button. The corresponding LED illuminates
he output state is shown on the NET ID display (“oF” for off, “On” for on) for two seconds after the button is
ased.
TE: The control system prog
Ov
The
valu ttings, refer to “Save Override Settings” below.
To e
NOTE:
erride Mode
Override mode overrides the control system program and sets all of the output states to the stored override
es. For instructions on saving override se
nable Override mode, press and release the OVR button. The OVR LED flashes slowly.
If the Override mode was enabled from an external device (i.e. a contact closure is present on the
OV flash quickly. Pressing the OVR button has no effect. ERRIDE terminals), the OVR LED will
To disable Override mode, press the OVR button again. The OVR LED extinguishes and the outputs return to the
states set by the control system program.
NOTE: If override states have not been stored, the factory default override state is all loads on.
Save Override Settings
The
mod
NO an prevent locally saving the override state. If this setting is
state of each output can be saved as an override setting, which can be automatically recalled when the Override
e is enabled.
TE: The control system program has a setting that c
enabled, the display shows “Er” when trying to save override states. For more information, refer to the SIMPL
Windows help file.
To save the states of all outputs as the override setting, press and hold the OVR button for three seconds until the
LED blinks once. The OVR LED blinks to indicate the new override setting has been stored.
System Operation and Commissioning
This cabinet has been des ponent of a programmed Crestron system. System commissioning by an
authorized Crestron representative
must
igned as a com
be performed to ensure system operation.
Once t
[1-8 ssioning.
he cabinet has been wired and the modules have been tested, contact Crestron at 1-888-CRESTRON
88-273-7876] to schedule commi
Installation Guide – DOC. 6888B GREEN LIGHT
®
EXPRESS Power Switching Cabinet GLPX-HSW-FT • 11