Filter
Top Products
CRESTRON GREEN LIGHT
®
EXPRESS Power Switching Cabinet GLPX-HSW-FT
Appendix A: Setting Module Net IDs
The following procedure will normally be performed by an authorized Crestron representative as part of the System
system wiring and basic testing as described on pages 7 and 11, it is not necessary to
ch module in the cabinet can be changed from the front panel of each module. The Net IDs of each
module in ust be uniqu
To e front p
the recessed SETU r the Setup mode.
2. As shown in the following diagram, press the left button u he left digit
of the Net ID or press the right button under the NET ID d
number.
Changing the Net ID
Commissioning phase. For
perform this step. Only perform this step if instructed by an authorized Crestron representative, or when replacing
modules on a system that have already been commissioned (in the latter case the Net ID should be set to match the
Net ID of the module being replaced).
The Net ID of ea
the system m e.
set the Net ID using th
1. Press
anel:
P button to ente The SETUP LED illuminates.
nder the NET ID display to change t
isplay to change the right digit of the Net ID
CHANGES
LEFT DIGIT
CHANGES
RIGHT DIGIT
LABEL FOR
NET ID
SETUP
BUTTON & LED
RIGHT DIGITLEFT DIGIT
et ID is displayed, press the SETUP button to exit the Setup mode. The SETUP LED 3. When the desired N
extinguishes.
If the SETUP button is not pressed, the Setup mode will time out after one minute of inactivity and the Net
ID will revert back to its original value.
Installation Guide – DOC. 6888B GREEN LIGHT
®
EXPRESS Power Switching Cabinet GLPX-HSW-FT • 13