Cypress CY8C24423A Computer Hardware User Manual


 
CY8C24223A, CY8C24423A
Document Number: 3-12029 Rev. *E Page 27 of 31
AC I
2
C Specifications
The following tables list guaranteed maximum and minimum specifications for the voltage and temperature ranges: 4.75V to 5.25V
and -40°C T
A
125°C. Typical parameters apply to 5V at 25°C and are for design guidance only.
Figure 16. Definition for Timing for Fast/Standard Mode on the I2C Bus
Table 28. AC Characteristics of the I
2
C SDA and SCL Pins
Symbol Description
Standard Mode Fast Mode
Units
Min Max Min Max
F
SCLI2C
SCL Clock Frequency 0 100 0 400 kHz
T
HDSTAI2C
Hold Time (repeated) START Condition. After this period, the first
clock pulse is generated.
4.0 –0.6 μs
T
LOWI2C
LOW Period of the SCL Clock 4.7 –1.3 μs
T
HIGHI2C
HIGH Period of the SCL Clock 4.0 –0.6 μs
T
SUSTAI2C
Setup Time for a Repeated START Condition 4.7 –0.6 μs
T
HDDATI2C
Data Hold Time 0 –0 μs
T
SUDATI2C
Data Setup Time 250 100
a
a. A Fast-Mode I2C-bus device can be used in a Standard-Mode I2C-bus system, but the requirement t
SU;DAT
250 ns must then be met. This is automatically the
case if the device does not stretch the LOW period of the SCL signal. If such device does stretch the LOW period of the SCL signal, it must output the next data
bit to the SDA line t
rmax
+ t
SU;DAT
= 1000 + 250 = 1250 ns (according to the Standard-Mode I2C-bus specification) before the SCL line is released.
–ns
T
SUSTOI2C
Setup Time for STOP Condition 4.0 –0.6 μs
T
BUFI2C
Bus Free Time Between a STOP and START Condition 4.7 –1.3 μs
T
SPI2C
Pulse Width of spikes are suppressed by the input filter. 0 50 ns
SDA
SCL
S
Sr SP
T
BUFI2C
T
SPI2C
T
HDSTAI2C
T
SUSTOI2C
T
SUSTAI2C
T
LOWI2C
T
HIGHI2C
T
HDDATI2C
T
HDSTAI2C
T
SUDATI2C
[+] Feedback