Filter
Top Products
dCS Verona User Manual Manual for Software Issue 1.0x
dCS Ltd September 2004
Manual filename: Verona Manual v1.0x.doc Page 14 email: more@dcsltd.co.uk
English version web-site: www.dcsltd.co.uk
THE SOFTWARE – THE MENU
Press "Step >" to move along the Menu, press "< Step" to move back.
Press "Select" to set a menu option or change options.
Menu Couple Bright x Time Out Test Issue
First page of the
Menu
Sets the format of
the Ext Ref Input
Sets the display
brightness
Sets the Menu time
-
out delay
Runs a display test
routine
Displays the
software version
number
TTL Bright 7 None 1.0x
Bipolar .... 5 seconds
Bright 0 15 seconds
30 seconds
1 min / 3 mins
End CDUpdate Factory Contact Serial Temp
Closes the Function
Menu
Starts software
update from a dCS
CD
Restores standard
factory settings
Displa
y
s dCS email
address
Displays the unit
full serial number
Displays the
internal
temperature
Celsius
Fahrenheit
Figure 4 – Menu flow chart
Using the Menu
The Menu gives the user access to a wide range of additional features. It also
allows new features and performance enhancements to be added at a later date
by software upgrades.
Opening the Menu
The Menu is controlled by three buttons:
• the Menu button opens the menu and doubles as the
Select button.
• the Step →
→→
→ button pages forward through the Menu – the
Step button.
• the ←
←←
← Step button pages backward through the Menu – the
Step Back
button.
When you first open the Menu, the display will show Menu.
Successive presses of the
Step button page through the Menu. You cannot go
directly to any particular page, but must enter at the top of the Menu and then
page through until you reach the page you want.
Types of Menu Page
There are three types of page in the Menu - Parameter Pages, Information
Pages and Test Pages.
Parameter pages allow the user to check and also change the current settings
of the operating parameters, for example Bright. When a parameter page is
displayed, the first press of the
Select button shows the current setting.
Subsequent presses of the
Select button change the page setting.
Information pages display information about the unit, for example Software
Issue. When an information page is displayed, pressing the
Select button
displays the information held on that page.