Dell 1012 Laptop User Manual


  Open as PDF
of 56
 
Back to Contents Page
Camera Module
Dell™Inspiron™1012ServiceManual
Removing the Camera Module
Replacing the Camera Module
Removing the Camera Module
1. Follow the procedures in Before You Begin.
2. Remove the battery (see Removing the Battery).
3. Remove the keyboard (see Removing the Keyboard).
4. Remove the hard-drive assembly (see Removing the Hard-Drive Assembly).
5. Remove the palm rest assembly (see Removing the Palm Rest Assembly).
6. Remove the hinge cover (see Removing the Hinge Cover).
7. Remove the display assembly (see Removing the Display Assembly).
8. Remove the display bezel (see Removing the Display Bezel).
9. Disconnect the camera cable from the connector on the camera module.
10. Gently remove the camera module stuck to the display cover.
Replacing the Camera Module
1. Follow the procedures in Before You Begin.
2. Use the alignment posts to place the camera module on the display cover.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
1
camera module
2
camera cable connector
 previous next