Dell 11 Laptop User Manual


 
Back to Contents Page
Processor Heat Sink
Dell™Inspiron™11ServiceManual
Removing the Processor Heat Sink
Replacing the Processor Heat Sink
Removing the Processor Heat Sink
1. Follow the procedures in Before You Begin.
2. Remove the battery (see Removing the Battery).
3. Remove the keyboard (see Removing the Keyboard).
4. Remove the palm rest (see Removing the Palm Rest).
5. Disconnect the speaker cable from the speaker cable connector on the I/O board (see Removing the Speakers).
6. Remove the hard drive (see Removing the Hard Drive).
7. Remove the memory module (see Removing the Memory Module).
8. Remove the palm rest bracket (see Removing the Palm Rest Bracket).
9. In sequential order (indicated on the processor heat sink), loosen the four captive screws that secure the processor heat sink to the system board.
10. Lift the processor heat sink off the system board.
Replacing the Processor Heat Sink
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: If you remove the processor heat sink from the computer when the heat sink is hot, do not touch the metal housing of the heat sink.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
1
captive screws (4)
2
processor heat sink
CAUTION: To ensure maximum cooling for the processor, do not touch the heat transfer areas on the processor heat sink assembly. The oils in
your skin can reduce the heat transfer capability of the thermal pads.