Filter
Top Products
9. Carefully lift the palm rest along the rear edge, near the hinge brackets, then gently lift the palm rest to remove it from the computer.
Replacing the Palm Rest
1. Align the palm rest with the base of the computer and gently snap it into place.
2. Replace the ten screws on the palm rest.
3. Connect the touch pad cable and speaker cable to the respective system board connectors.
4. Connect the display cable, camera cable, and power button cable to the respective system board connectors (see Replacing the Display Assembly).
5. Slide the antenna cables through their cable routing (see Replacing the Display Assembly).
6. Replace the Mini-Cards (see Replacing the Mini-Card).
7. Replace the eight screws at the bottom of the computer.
8. Replace the base cover (see Replacing the Base Cover).
Back to Contents Page
1
screws (10)
2
power button connector
3
touch pad connector
4
display cable connector
5
camera cable connector
6
speaker connector