Dell 1555 Laptop User Manual


  Open as PDF
of 49
 
Back to Contents Page
USB Connector
DellStudio™1555ServiceManual
Removing the USB Connector Cable
Replacing the USB Connector Cable
Removing the USB Connector Cable
1. Follow the procedures in Before You Begin.
2. Remove the optical drive (see Removing the Optical Drive).
3. Remove the AC adapter connector (see Removing the AC Adapter Connector).
4. Remove the screw that secures the USB connector.
5. Remove the USB connector cable from the routing guide.
6. Disconnect the USB connector cable from the system board connector.
7. Lift the connector and cable out of the computer base.
Replacing the USB Connector Cable
1. Place the USB connector cable in the computer base.
2. Replace the screw that secures the USB connector.
3. Route the USB connector cable through the routing guide.
4. Connect the USB connector cable to the system board connector.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as the back panel) on the computer.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see Before Working Inside Your Computer) before working
inside the computer.
1
USB cable connector
2
screw
3
USB connector cable routing
 previous