Filter
Top Products
Operator Panel Menus
Network Menu
Parallel Menu
Setup Menu
USB Menu
Utilities Menu
Menus are represented by Ready , Toner Low/Replace Drum / , Load Paper/Remove Output / , and
Paper Jam
light sequences. Menu items and their settings are indicated by Error and Continue light sequences.
Press the Cancel button to advance through the menus and menu items.
Press the Continue button to advance to the setting you need.
Press and hold the Continue button until all the lights cycle to save a setting.
Press and hold the Cancel button until all of the lights cycle to return to the Home menu.
Turn off the printer to exit the menus.
Network Menu
Use the Network menu to change printer settings on jobs sent through a network port (either Standard Network or
Network Opt <x>).
From this
menu:
You can:
* Factory default setting
NPA Mode Send print jobs to the printer and query printer status information simultaneously.
Off
On*
MAC Binary PS Configure the printer to process Macintosh binary PostScript print jobs.
Off—the printer filters PostScript print jobs using standard protocol.
On—the printer processes raw binary PostScript print jobs from computers using the Macintosh
operating system.
NOTE: This setting can cause print jobs sent from Windows to fail.
Auto*—the printer processes print jobs from computers using either Windows or Macintosh
operating systems.
Set Card Speed Automatically detect the connection speed of your network. You can disable this setting to set the
speed manually.
Auto*—the printer attempts to connect to the network at the current network speed.
10 Mbps, Half Duplex—the printer attempts to connect to the network at 10 Mbps, Half Duplex.
10 Mbps, Full Duplex—the printer attempts to connect to the network at 10 Mbps, Full Duplex.
100 Mbps, Half Duplex—the printer attempts to connect to the network at 100 Mbps, Half Duplex.
100 Mbps, Full Duplex—the printer attempts to connect to the network at 100 Mbps, Full Duplex.