Dell 1900 Personal Computer User Manual


 
Installing System Components 79
Installing the Cooling Shroud
To install the cooling shroud, align the rails on the right side of the shroud with the tracks on the right
chassis wall and then slowly lower the shroud straight down into the system until the fan connector
engages and the latches snap into place. See Figure 3-19.
NOTICE: Never operate your system with the memory cooling shroud removed. Overheating of the system can
develop quickly resulting in a shutdown of the system and the loss of data.
Fan Brackets
Removing the Center Fan Bracket
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. See your Product Information Guide for complete information about safety
precautions, working inside the computer, and protecting against electrostatic discharge.
1
Turn off the system, including any attached peripherals, and disconnect the system from the electrical
outlet.
2 Open the system. See
"Opening the System" on page 48
.
3
If applicable, disconnect the cables from the SAS RAID controller daughter card or expansion card on
the expansion-bay bracket and pull the cables out of the way of the center fans. See "Removing the
SAS RAID Controller Daughter Card" on page 93.
4 Remove the fans from the center fan bracket. See
"Removing and Installing a Fan" on page 53
.
5 To release the fan bracket, use your index fingers and push inward on the blue latches on each end
of the center fan bracket. Then slide the bracket straight up and out of the system. See
Figure 3-19
.
If the bracket does not disengage completely, push down slightly on the bracket when releasing the
latches.
Replacing the Center Fan Bracket
1
Align the rails on each end of the fan bracket with the guide rails on the chassis walls and lower the
bracket down into the system until the latches engage.
2
Replace the fans into the fan bracket. See "Removing and Installing a Fan" on page 53.
3
If applicable, reconnect the cables to the SAS RAID controller daughter card or expansion card. See
"Installing the SAS RAID Controller Daughter Card" on page 95.
4 Close the system. See
"Closing the System" on page 48
.
5
Reconnect the system to the electrical outlet and turn on the system and attached peripherals.