Filter
Top Products
Setup Wizard Basic Configuration of the Filer3-5
4. From a client attached to the network, point your browser to the filer address
given; the Setup Wizard loads.
5. Enter the information as requested.
:KHUHWR*R)URP+HUH
Verify the network connections of your new filer using the procedure in "Verifying Net-
work Connections."
9HULI\LQJ1HWZRUN&RQQHFWLRQV
'HVFULSWLRQ
After you configure the filer, you use the
ping
command from a client attached to the
network to verify that the filer is set up correctly and can communicate with other
computers on the network.
6WHSV
To verify filer communication, perform the following steps:
1. At a client attached to the network, enter the following command:
SLQJILOHULSDGGUHVV!
2. Replace
<filer ipaddress>
with the Internet protocol (IP) address that you
assigned the filer.
3. Repeat the test for each interface that is installed in the filer.
([DPSOHV
The following examples test the network connections for a filer that has the host
name
filer
with two interfaces named
e0
and
f0
installed:
SLQJILOHUH
SLQJILOHUI
7URXEOHVKRRWLQJ
If an interface does not respond to a
ping
command, make sure that:
The interface is securely attached to the network.
The media type is set up correctly if the interface is on an Ethernet card contain-
ing different media connectors.
The routers function properly with correct routing information if the
ping
com-
mand is issued from a network not directly attached to the interface.