Filter
Top Products
4. Push the two release tabs on the card retention door from the inside to pivot the door open; the hinged door will remain in the open position.
5. If you are installing a new card, remove the filler bracket to create a card-slot opening. Then continue with step 7.
6. If you are replacing a card that is already installed in the computer, remove the card.
If necessary, disconnect any cables connected to the card. Grasp the card by its top corners, and ease it out of its connector.
7. Prepare the card for installation.
See the documentation that came with the card for information on configuring the card, making internal connections, or otherwise customizing it for your
computer.
8. Place the card in the connector and press down firmly. Ensure that the card is seated fully in the slot.
1
release tab
2
card retention mechanism
3
card retention door
1
release tabs (2)
2
filler bracket
3
alignment guide
4
alignment bar
5
card retention door
CAUTION: Some network adapters automatically start the computer when they are connected to a network. To guard against electrical shock, be
sure to unplug your computer from its electrical outlet before installing any cards.