Filter
Top Products
152 Removing and Installing Parts
11
Replace the CD/DVD drive (see "Installing a CD/DVD Drive" on
page 155).
12
Replace the bezel (see "Replacing the Bezel" on page 136).
13
Replace the computer cover (see "Replacing the Computer Cover" on
page 174).
14
Connect your computer and devices to electrical outlets, and then turn
them on.
Installing a Media Card Reader
1
Follow the procedures in "Before You Begin" on page 103.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 105).
3
Remove the bezel (see "Removing the Bezel" on page 135).
4
If this is a new card reader installation:
• Remove the drive panel insert (see "Removing the FlexBay Drive Panel
Insert" on page 149).
• Remove the Media Card Reader from its packaging.
5
Remove the CD/DVD drive (see "Removing a CD/DVD Drive" on
page 154).
6
Remove the FlexBay drive insert (see "Removing the FlexBay Drive Panel
Insert" on page 149).
7
Press the two spring clamps and slide out the FlexBay drive cage from the
front of the system (see "Removing a Floppy Drive" on page 144).
8
Place the Media Card Reader in the FlexBay drive cage and slide the
Media Card Reader in to align the screw holes in the Media Card Reader
with the cage notch.
9
Tighten the two screws to secure the floppy drive in the FlexBay drive cage.
10
Slide the FlexBay drive cage along with the floppy drive in the FlexBay slot
till it snaps in place.
11
Connect the FlexBay USB cable to the back of the Media Card Reader and
to the internal USB connector on the system board (see "Inside View of
Your Computer" on page 108).
book.book Page 152 Monday, October 6, 2008 11:38 AM