Filter
Top Products
Back to Contents Page
Keyboard
Dell™Inspiron™XPSandInspiron9100ServiceManual
1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Open the display.
3. Remove the center hinge cover.
4. Remove the keyboard:
a. Remove the two M2.5 x 3-mm screws across the top of the keyboard.
b. Lift up the keyboard and gently slide it toward the display.
c. Hold the keyboard up and slightly forward to allow access to the keyboard connector.
d. Pull up on the keyboard connector tab to disconnect the keyboard connector from the system board.
CAUTION: Before performing the following procedures, read the safety instructions in your Owner's Manual.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
NOTE: You do not need to remove the left and right hinge covers.
NOTICE: The keycaps on the keyboard are fragile, easily dislodged, and time-consuming to replace. Be careful when removing and handling the
keyboard.
1
keyboard
2
M2.5 x 3-mm screws (2)
3
keyboard connector tab
4
system board connector
NOTICE: To avoid scratching the palm rest when replacing the keyboard, hook the four tabs along the front edge of the keyboard into the palm rest,
and then secure the keyboard in place.