Filter
Top Products
Back to Contents Page
Palm Rest
Dell™Inspiron™XPSandInspiron9100ServiceManual
1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the left, right, and center hinge covers.
3. Remove the keyboard.
4. Remove the display assembly.
5. Remove the keyboard bracket.
6. Turn over the computer and remove the three M2.5 x 8-mm screws labeled "P."
7. Turn the computer top-side up and remove the four M2.5 x 6-mm screws labeled "P."
8. Disconnect the touch-pad connector from the system board.
9. Slide the palm rest forward and remove it from the computer.
CAUTION: Before performing the following procedures, read the safety instructions in your Owner's Manual.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
1
M2.5 x 8-mm screws labeled "P" (3)