Filter
Top Products
5. Disconnect the speaker interface cables. (Do not attempt to disconnect the antenna cables.)
NOTICE: Do not pull the antenna wire when removing the speaker.
NOTICE: Handle the speaker assemblies and speakers carefully to avoid damaging the speaker cones.
6. Remove the speaker assemblies by pulling them straight out of the bottom case.
7. Remove the speakers from the holders by sliding the speakers out of the bottom of the holders.
NOTE: The left speaker has an in-line connector; the left antenna cable is longer than the right antenna cable.
Replacing the Speaker Assemblies
For each speaker:
1. Slide the new speaker into its holder so that the speaker will face outward (toward the speaker grill on the side of the
computer) when the speaker assembly is installed.
2. Place the mounting ring over the front palm-rest screw post.
3. Slide the speaker assembly down into the bottom case.
NOTICE: Ensure that the speaker wires are routed securely under their mounting clips.
Back to Contents Page