Filter
Top Products
182 Installing System Components
Installing the Hard-Drive Tray
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1
Insert the sled tray’s standoff holes into the sled tray standoffs.
See Figure 3-36.
2
Replace the three screws securing the hard-drive tray. See Figure 3-36.
3
Replace the internal hard-drives. See "Installing a Hard-Drive Carrier" on
page 179.
4
Replace the back cover. See "Installing the Back Cover" on page 141.
5
Replace the sled. See "Installing a Sled" on page 134.
Interposer Extender
The following table lists the types of interposer extenders supported for a
specific system board model.
NOTE: For information about identifying the sled’s system board model number,
see "Identifying System Board Model Number" on page 209.
Removing the Interposer Extender
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1
Remove the sled from the enclosure. See "Removing a Sled" on page 133.
2
Remove the back cover. See "Removing the Back Cover" on page 140.
System Board Interposer Extender
V1.0 V1.0
V1.1 V1.1
V1.2 V1.1