Filter
Top Products
Removing and Installing Parts 71
5
Secure the floppy drive bracket with the top bracket screw that came with your drive.
6
Reattach the front panel (see page 64).
7
Connect the data cable to the back of the drive and to the floppy drive connector on the system board
(see page 54).
NOTICE: Match the colored strip on the cable with pin 1 on the drive (pin 1 is marked as "1").
8
Reattach the front panel (see page 64).
9
Replace the computer cover (see page 77).
NOTICE: To connect a network cable, first plug the cable in to the network wall jack and then plug it in to the
computer.
10
Connect your computer and devices to their electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for
drive operation.
11
Enter system setup (see page 82) and update the appropriate
Diskette Drive
option.
12
Verify that your computer works correctly by running the Dell Diagnostics (see page 38).
power cable
data cable