Filter
Top Products
112 Adding and Replacing Parts
To replace the hard drive in the hard drive bay:
1
Follow the procedures in "Before You Begin" on page 109.
2
Turn the computer over, and loosen the two captive screws in the hard drive cover.
NOTICE: When the hard drive is not in the computer, store it in protective antistatic packaging. See "Protecting
Against Electrostatic Discharge" in the Product Information Guide.
3
Lift the cover off the computer and set it aside.
4
Use your finger to slide the hard drive toward the screw holes, and then use the pull-tab to lift the hard
drive straight up to remove it from the computer.
1 screws (2)
1