Filter
Top Products
Dell
™
Latitude™ E6400 XFR Service Manual
Page 61
CAUTION: Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
1. Place the RJ-11 modem connector into the base assembly, aligning the guides on the connector sides with the
base. Once installed, press down firmly on top of the RJ-11 connector to seal the adhesive to the base.
2. Replace the modem (see Replacing the Modem
).
3. Replace the palm rest, keyboard, palm rest overlay, led cover, display assembly, LCD cable channel covers
and bottom access panel (see Replacing the Palm Rest
).
4. Follow the procedures in After Working on Your Computer
.
1 I/O card 2
RJ-11 modem card
3 M2.5 x 5-mm screw
4
Modem connector
33 DC Power Cable
33.1 Removing the DC Power Cable
CAUTION: Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
1. Follow the instructions in Before Working on Your Computer
.
2. Remove the system board (see Removing the System Board Assembly
).
NOTE: Do not remove the mini-pci wireless or FCM cards, memory modules, or processor from
the system board.
3. Unroute the DC power cable from the base assembly. Pry up the DC power connector to release the double-
stick adhesive tape on the bottom of the connector, and then lift the DC power connector out of the base
assembly.
1 DC power connector
2
DC cable
1
2
1
2
3
4