Filter
Top Products
Back to Removing and Replacing Parts
Bluetooth Card
Dell™Latitude™E6410/E6410ATGServiceManual
Removing the Bluetooth Card
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the ATG Port Cover (applicable on E6410 ATG computer only).
3. Remove the battery.
4. Remove the SIM card.
5. Remove the SD card.
6. Remove the ExpressCard.
7. Remove the Smart card.
8. Remove the hinge covers.
9. Remove the access panel.
10. Remove the optical drive.
11. Remove the hard drive.
12. Remove the LED cover.
13. Remove the keyboard.
14. Remove the coin-cell battery.
15. Remove the memory.
16. Remove the WWAN card.
17. Remove the WLAN card.
18. Remove the LatitudeON™Flash/CMGmodule.
19. Remove the Fingerprint Reader.
20. Remove the Heat Sink and Processor Fan.
21. Remove the screw that secures the Bluetooth card to the computer.
22. Disconnect the Bluetooth cable from the computer.
23. Remove the Bluetooth card from the computer.
Replacing the Bluetooth Card
To replace the Bluetooth card, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.