Filter
Top Products
Back to Removing and Replacing Parts
Power Connector
Dell™Latitude™E6410/E6410ATGServiceManual
Removing the Power Connector
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the ATG Port Cover (applicable on E6410 ATG computer only).
3. Remove the battery
4. Remove the Memory.
5. Remove the ExpressCard.
6. Remove the optical drive.
7. Remove the hard drive.
8. Remove the hinge covers.
9. Remove the access panel.
10. Remove the LatitudeON™Flash/CMGmodule.
11. Remove the WWAN card.
12. Remove the WLAN card.
13. Remove the coin-cell battery.
14. Remove the LED cover.
15. Remove the keyboard.
16. Remove the Fingerprint Reader.
17. Remove the Display Assembly.
18. Remove the ExpressCard cage.
19. Remove the palm rest.
20. Remove the system board.
21. Unthread the power source cable from the computer.
22. Lift up the power source port to remove from the computer.
Replacing the Power Connector
To replace the power connector, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.